The accessory is a universal remote with an extra signal cable soldered on it. You only need to pair the remote with your garage door opener. Once you can use the remote to control the garage door opener, you need to connect the remote to the device using the signal cables and launch the Meross app to set it up (Yellow learn button accessory and Other learn button accessory). Afterward, the smart garage door opener will work with your garage door opener.
To claim the accessory, you can contact us at https://www.meross.com/support/email and provide us information listed below:
1.Your Amazon order number or receipt.
2.The brand, model and learn button color (if any) of your ceiling garage door opener.
3.Your delivery address.
4.A phone number that can reach you (optional)
You can troubleshoot as the following steps:
1.Make sure the two magnetic sensors are close to each other, within 3cm(1 inch), when the garage door is fully closed and vice versa;
2.Unplug and plug the sensor cables, check there’s no any wire damage;
3.Do not install the sensors directly on any metal rails. For instance, you can use the material such as PVC to isolate the sensors from metal to avoid magnetic interference.
4.Factory reset the smart garage door opener and set up it from the scratch.
5.Completely reinstall Meross app.